Administrator Guide

Data Center Technology Commands 1191
When the switch groups parameter is given, the following information is
displayed:
When the switch flows parameter is selected, the following output is shown:
Command History
Introduced in version 6.3.0.1 firmware.
Parameter Description
Group Type Type of Group: Indirect, All, Select, etc.
Group Id Unique ID for the Group
Refence Count This count indicates how many Select groups are referring
to the current Indirect group. Reference Count is used
only for Indirect groups.
Duration The time since the group was created.
Bucket Count Number of Buckets in the group.
Reference Group Id References the Indirect group ID and used for Select
group only.
Parameter Description
Flow Type Type of the Flow 1.0 Flow or Layer 2 Match etc.
Flow Table The hardware table where the flow is installed.
Flow Priority Priority of the flow versus other flows. Higher is better.
Match Criterion The match criterion specified by the flow with the field
and value like ingress port or ether type
Ingress Port The port on which the flow is active.
Action The action specified by the flow.
Duration The time since the flow was created
Idle The time since the flow was hit.
Installed in hardware Shows 0 if for some reason the flow could not be added in
the hardware.
2CSNXXX_SWUM204.book Page 1191 Monday, January 25, 2016 1:25 PM