Administrator Guide

Layer 3 Routing Commands 1217
next hops in its route to the destination are through interfaces other than the
interface that received the ARP request. Use the no form of the command to
disable proxy ARP on a router interface.
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
Enabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The ip proxy-arp command is not available in interface range mode.
Example
The following example enables proxy arp for VLAN 15.
(config)#interface vlan 15
console(config-if-vlan15)#ip proxy-arp
show arp
Use the show arp command in Privileged Exec mode to display all entries in
the Address Resolution Protocol (ARP) cache. The displayed results are not
the total ARP entries. To view the total ARP entries, the operator should view
the show ARP results.
Syntax
show arp [vrf vrf-name ][brief]
•
vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
• brief — Display ARP parameters.
2CSNXXX_SWUM204.book Page 1217 Monday, January 25, 2016 1:25 PM