Administrator Guide

Dell Networking CLI 121
Loop Protection
MLAG
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see Mode Types on page 100.
keepalive (Interface Config) Enables loop protection on an interface. IC
keepalive (Global Config)
Globally enable loop protection and
optionally configure the loop protection
timer and packet count.
GC
keepalive action
Configure the action taken when a loop
is detected on an interface.
IC
show keepalive Displays the global loop protect
configuration.
PE
show keepalive statistics Displays the loop protect status for one
or all interfaces.
PE
Command Description Mode
a
clear vpc statistics Clears the counters for the keepalive
messages transmitted and received by the
MLAG switch.
PE
feature vpc Enables debug traces for the specified
protocols.
GC
feature vpc Globally enables MLAG. GC
peer detection enable
Enables the Dual Control Plane
Detection Protocol.
MD
peer detection interval
Configures the peer detection
transmission interval and the detection
interval.
MD
peer-keepalive destination Enables the Dual Control Plane Detection
Protocol with the configured IP address of
the peer MLAG, the local source address and
the peer timeout value.
MD
peer-keepalive enable Enables the peer keepalive protocol. MD
2CSNXXX_SWUM204.book Page 121 Monday, January 25, 2016 1:25 PM