Administrator Guide

Layer 3 Routing Commands 1230
Border Gateway Protocol
Commands
Dell Networking N3000/N4000 Series Switches
This section describes the commands you use to view and configure Border
Gateway Protocol (BGP), which is an exterior gateway routing protocol that
you use to route traffic between autonomous systems. The BGP CLI
commands are available in the N3000/N4000 Series switches. On the N3000
Series switches, the BGP specific firmware must be loaded (e.g.,
N3000_BGPvA.B.C.D.stk.
CAUTION:
The commands in this section are in one of three functional groups.
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For
every configuration command, there is a show command that displays the
configuration setting.
• Clear commands reset part of the protocol state.
Commands in this Section
This section explains the following commands:
router bgp maximum-paths (IPv6
Address Family
Configuration)
redistribute (BGP Router
Configuration)
address-family maximum-paths ibgp (BGP
Router Configuration)
redistribute (IPv6 Address
Family Configuration)
address-family ipv4 vrf maximum-paths ibgp (IPv6
Address Family
Configuration)
route-target
address-family ipv6 neighbor activate set extcommunity rt
address-family vpnv4
unicast
neighbor advertisement-
interval (BGP Router
Configuration)
set extcommunity soo
2CSNXXX_SWUM204.book Page 1230 Monday, January 25, 2016 1:25 PM