Administrator Guide

Layer 3 Routing Commands 1251
bgp log-neighbor-changes
Use the bgp log-neighbor-changes command to enable logging of adjacency
state changes.
Syntax
bgp log-neighbor-changes
no bgp log-neighbor-changes
Default Configuration
Neighbor state changes are not logged by default.
Command Mode
BGP Router Configuration mode
User Guidelines
Both backward and forward adjacency state changes are logged. Forward state
changes, except for transitions to the Established state, are logged at the
Informational severity level. Backward state changes and forward changes to
Established are logged at the Notice severity level
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)# bgp log-neighbor-changes
bgp maxas-limit
Use this command to specify a limit on the length of AS Paths that BGP
accepts from its neighbors. To revert the limit to its default, use the no form
of this command.
Syntax
bgp maxas-limit limit
no bgp maxas-limit
2CSNXXX_SWUM204.book Page 1251 Monday, January 25, 2016 1:25 PM