Administrator Guide
Layer 3 Routing Commands 1263
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#distance bgp 20 200 200
distribute-list prefix in
Use this command to configure a filter that restricts the routes that BGP
accepts from all neighbors based on destination prefix.
Syntax
distribute-list prefix
list-name
in
no distribute-list prefix
list-name
in
•
list-name
—A prefix list used to filter routes received from all peers based
on destination prefix.
Default Configuration
No distribute lists are defined by default.
Command Mode
• BGP Router Configuration mode
• IPv6 Address Family Configuration mode
User Guidelines
The distribute list is applied to all routes received from all neighbors. Only
routes permitted by the prefix list are accepted. If the command refers to a
prefix list that does not exist, the command is accepted and all routes are
permitted.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#distribute-list prefix 255 in
2CSNXXX_SWUM204.book Page 1263 Monday, January 25, 2016 1:25 PM