Administrator Guide

Layer 3 Routing Commands 1289
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#neighbor FE80::0202:B3FF:FE1E:8329 default-
originate
neighbor description
Use this command to record a text description of a neighbor. The description
is informational and has no functional impact.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-name ] |
autodetect interface
interface-id } description text
no neighbor { ip-address | ipv6-address [ interface interface-name
]autodetect interface
interface-id } description
• ip-address —The neighbor’s IP address.
•
ipv6-address [ interface interface-name ]—The neighbor’s IPv6 address. If
the neighbor’s IPv6 address is a link local address, the local interface must
also be specified. The
interface-id must specify a routing interface
identifier (VLAN ID).
•
text —Text description of neighbor. Up to 80 characters are allowed.
•
autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface.
Default Configuration
No description is configured by default.
Command Mode
BGP Router Configuration mode
IPv4 Address Family Configuration mode
2CSNXXX_SWUM204.book Page 1289 Monday, January 25, 2016 1:25 PM