Administrator Guide

Layer 3 Routing Commands 1290
User Guidelines
There are no user guidelines for this command.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 description Test-
System
neighbor ebgp-multihop
Use the neighbor ebgp-multihop command to configure BGP to form
neighborship with external peers that are not directly connected.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface
interface-id } ebgp-multihop hop-count
no neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface
interface-id } ebgp-multihop hop-count
• ip-address — The neighbor’s IPv4 address. This is the IP address of the
neighbor on the connected link.
•
ipv6-address — The neighbor’s IPv6 address. If the neighbor’s IPv6
address is a link local address, the local interface must also be specified.
Valid in IPv6 address family configuration mode.
•
interface interface-id — The local VLAN routing interface over which the
IPv6 neighbor can be reached or is auto-detected. Use the vlan keyword
and a VLAN ID. Range 1-4093.
•
autodetect interface interface-id — The VLAN routing interface on which
the neighbor’s link local IPv6 address is auto detected. Use the vlan
keyword and a VLAN ID. Range 1-4093.
•
hop-count — The maximum hop-count allowed to reach the neighbor.
The allowed range is 1–255.
2CSNXXX_SWUM204.book Page 1290 Monday, January 25, 2016 1:25 PM