Administrator Guide

Layer 3 Routing Commands 1294
no neighbor { ip-address | ipv6-address [ interface interface-id ]} filter-list
as-path-list-number {in | out}
• ip-address —The neighbor’s IPv4 address.
•
ipv6-address [ interface interface-id ]—The neighbor’s IPv6 address. If the
neighbor’s IPv6 address is a link local address, the local interface must also
be specified.
•
as-path-list-number —Identifies an AS path list.
•
in —The AS Path list is applied to advertisements received from the
neighbor.
•
out —The AS Path list is applied to advertisements to be sent to the
neighbor.
Default Configuration
No neighbor filter lists are configured by default.
Command Mode
BGP Router Configuration mode
User Guidelines
If you assign a neighbor filter list to a nonexistent AS path access list, all
routes are filtered.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#neighbor FE80::0202:B3FF:FE1E:8329 filter-list 1
in
neighbor inherit peer
To configure a BGP peer to inherit peer configuration parameters from a peer
template, use the neighbor inherit peer command. To remove the
inheritance, use the no form of this command.
2CSNXXX_SWUM204.book Page 1294 Monday, January 25, 2016 1:25 PM