Administrator Guide

Layer 3 Routing Commands 1330
Command Mode
IPv6 Address Family Configuration mode
User Guidelines
The distribute-list out command can also be used to filter redistributed
routes by prefix. Either a redistribute route map or a distribute list may be
configured, but not both.
Successive invocations of the redistribute command are additive. The
redistribute command does not overwrite previous redistribute command
configuration or the default configuration. Use the no redistribute command
to remove the redistribution of internal or external routes.
A default route cannot be redistributed unless the default-information-
originate command is given.
In IPv6 address family configuration mode, the syntax and behavior is the
same as for IPv4, except that Dell Networking does not support RIP for IPv6.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#redistribute rip
route-target
Use the route-target command to create a list of export, import, or both route
target (RT) extended communities for the specified VRF instance.
Use the no form of the command to remove the route target from a VRF
instance.
Syntax
route-target {export | import | both} rt-ext-comm
no route-target {export | import | both} rt-ext-comm
• export — Exports routing information to the target VPN extended
community.
2CSNXXX_SWUM204.book Page 1330 Monday, January 25, 2016 1:25 PM