Administrator Guide

Layer 3 Routing Commands 1343
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode and all show modes
User Guidelines
• "RFC 5549 Support" is displayed only if the BGP neighbor is peered over
IPv6 network.
• If the peer is configured as “autodetect”, the “Remote Address” shows
detected IPv6 address or “Unresolved” in case if the peer is not detected by
the autodetect feature.
• “Autodetect status” is displayed only if the peer is configured as
“autodetect”. The field shows one of the following statuses:
• Peer is detected
• Peer is not detected
• Multiple peers are detected
The following fields are displayed.
Field Description
Remote Address The neighbor’s IPv6 address. If this is a link local
address, the next line indicates the scope of the address.
Remote AS The neighbor’s autonomous system number
Peer ID The neighbor’s BGP router ID
Peer Admin Status START or STOP
Peer State The adjacency state of this neighbor
Peer Type The type of peer
Listen Range The ports that are being listened to.
Local Port TCP port number on the local end of the connection
Remote Port TCP port number on the remote end of the connection
Connection Retry Interval How long BGP waits between connection retries
2CSNXXX_SWUM204.book Page 1343 Monday, January 25, 2016 1:25 PM