Administrator Guide

Layer 3 Routing Commands 1350
show bgp ipv6 neighbors policy
Use this command to display the inbound and outbound IPv6 policies
configured for a specific peer. The output distinguishes policies that are
configured on the peer itself and policies that the peer inherits from a peer
template. This command deprecates and replaces the show ipv6 bgp
neighbors policy command.
Syntax
show bgp ipv6 neighbors [ ipv4-address | ipv6-address [ interface interface-id
] ] policy
• ipv4-address —The IPv4 address of a neighbor may optionally be specified
to limit the output to a single neighbor.
•
ipv6-address [ interface interface-id ]—The IPv6 address of a neighbor. If
specified, the output shows only this neighbor. If the neighbor’s address is
a link local address, the interface must be specified.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC and all show modes
User Guidelines
The following fields are displayed.
Command History
Introduced in version 6.2.0.1 firmware.
Field Description
Neighbor The peer address of a neighbor.
Policy A neighbor-specific BGP policy.
Template If the policy is inherited from a peer template, this field
lists the template name.
2CSNXXX_SWUM204.book Page 1350 Monday, January 25, 2016 1:25 PM