Administrator Guide

Layer 3 Routing Commands 1354
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console # show bgp ipv6 statistics
Delta T Phase Upd Grp GenId Reason Peer Duration Adds Mods
Dels
29:33:49 3 0 2041 Fwd status chng 34 750 0 500
29:33:40 2 2042 Accept-RIB-In- 59 750 0 500
29:33:28 2 2043 Accept-RIB-In- 10 0 0 250
29:23:40 2 2044 Accept-RIB-In- 32 0 0 1000
29:13:40 3 1 2044 Phase 2 done 48 500 2500 1750
29:02:01 3 0 2044 Phase 2 done 41 750 0 1250
28:33:40 2 2045 Phase 1 done 32 500 0 0
28:14:40 2 2046 Phase 1 done 16 250 0 0
show bgp ipv6 summary
Use this command to display a summary of BGP configuration and status.
This command deprecates and replaces the show ipv6 bgp summary
command.
Reason The event that triggered the decision process to run
Peer Phase 1 of the decision process can be triggered for a
specific peer when a peer’s inbound routing policy
changes or the peer is reset. When phase 1 is run for a
single peer, the peer’s IP address is given.
Duration How long the decision process took, in milliseconds
Adds The number of routes added. For phase 1, this is the
number of prefixes that pass inbound policy and are
added to the Accept-RIB-In. For phase 2, this is the
number of routes added to the BGP routing table. For
phase 3, this is the number of prefixes added to the
update group’s Adj-RIB-Out.
Mods The number of routes modified. Always 0 for phase 1
Dels The number of routes deleted. Always 0 for phase 1.
2CSNXXX_SWUM204.book Page 1354 Monday, January 25, 2016 1:25 PM