Administrator Guide

Layer 3 Routing Commands 1357
Local AS Number ............................... 65001
Traps ......................................... Disable
Maximum Paths ................................. 1
Maximum Paths iBGP ............................ 1
Default Keep Alive Time ....................... 30
Default Hold Time ............................. 90
Number of Network Entries ..................... 0
Number of AS Paths ............................ 0
Dynamic Neighbors Current/High/Limit .......... 1/1/20
Default Metric ................................ Not Configured
Default Route Advertise ....................... No
Redistributing:
Source Metric Dist List Route Map
--------- ---------- -------------------------------- ----------------------
Neighbor ASN MsgRcvd MsgSent State Up/Down Time Pfx Rcvd
---------------- ----- -------- -------- ------------- -------------- ------
fe80::21e:c9ff:fede:b13a%Vl10
65000 137 136 ESTABLISHED 0
show bgp ipv6 update-group
Use this command to report the status of IPv6 outbound groups and their
members. Output and format are the same as for show ip bgp update-group.
This command deprecates and replaces the show ipv6 bgp update-group
command.
Syntax
show bgp ipv6 update-group [ group-index | ipv4-address | ipv6-address [
interface
interface-id ] | autodetect interface interface-id ]
• group-index —If specified, this option restricts the output to a single
update group.
•
ipv4-address —The IPv4 address of a peer enabled for exchange of IPv6
prefixes. If specified, this option restricts the output to the update group
containing the peer with the given address.
2CSNXXX_SWUM204.book Page 1357 Monday, January 25, 2016 1:25 PM