Administrator Guide

Layer 3 Routing Commands 1370
Peer State The adjacency state of this neighbor
Local Port TCP port number on the local end of the connection
Remote Port TCP port number on the remote end of the connection
Connection Retry Interval How long BGP waits between connection retries
Neighbor Capabilities Optional capabilities reported by the neighbor,
recognized and accepted by this router. Codes listed in
the show output are as follows:
•MP: Multiprotocol
• RF: Route Refresh
This version of Dell Networking does not support any
multiprotocol AFI/SAFI pairs other than IPv4 unicast.
The presence of this capability does not imply
otherwise.
Next Hop Self If the local router is configured to advertise one of its
own IP addresses as the BGP Next Hop when
advertising a path learned from an external peer.
Update Source The configured value for the source IP address of
packets sent to this peer. This field is only included in
the output if the update source is configured.
Local Interface Address The IPv4 address used as the source IP address in
packets sent to this neighbor.
Configured Hold Time The time, in seconds, that this router proposes to this
neighbor as the hold time
Configured Keep Alive
Time
The configured KEEPALIVE interval for this neighbor.
Negotiated Hold Time The minimum configured hold time and the hold time
in the OPEN message received from this neighbor. If the
local router does not receive a KEEPALIVE or UPDATE
message from this neighbor within this interval of time,
the local router drops the adjacency. This field is only
shown if the adjacency state is OPEN CONFIRM or
greater.
Keep Alive Time The number of seconds between KEEPALIVE messages
sent to this neighbor. This field is only shown if the
adjacency state is OPEN CONFIRM or greater.
2CSNXXX_SWUM204.book Page 1370 Monday, January 25, 2016 1:25 PM