Administrator Guide

Layer 3 Routing Commands 1382
Example
console # show ip bgp route-reflection
Cluster ID........................ 1.1.1.1 (configured)
Client-to-client Reflection....... Enabled
Clients: 172.20.1.2, 172.20.3.2, 172.20.5.2
Non-client Internal Peers: 192.168.1.2, 192.168.2.2
Skipping set statements in outbound route map gandolf when reflecting to
internal peer 172.20.1.2.
show ip bgp statistics
This command displays recent decision process history. Phase 1 of the
decision process reacts to UPDATE messages received from peers,
determining what new routes are accepted and deleting withdrawn routes
from the Adj-RIB-In. Phase 2 determines the best path for each destination,
updates the BGP route table, and updates the common RIB. Phase 3 is run
independently for each outbound update group and determines which routes
should be advertised to neighbors in each group. Each entry in the table
shows statistics for one phase of the decision process. The table shows the 20
most recent decision process runs, with the most recent information at the
end of the table.
Syntax
show ip bgp [vrf vrf-name ] statistics
• vrf vrf-name — Displays the aggregate address information associated
with the named VRF.
Default Configuration
By default, information about the global VRF is shown.
Command Mode
User Exec mode, Privileged EXEC mode, Global Config mode and all sub-
modes.
2CSNXXX_SWUM204.book Page 1382 Monday, January 25, 2016 1:25 PM