Administrator Guide

Layer 3 Routing Commands 1389
The output shows when BGP counters were last cleared (using clear ip bgp
counters). Clearing counters resets all values in this output to 0 except for
the high water mark for the work queues.
The first table lists the number of BGP messages of each type that this router
has sent and received. Following the table is a maximum send and receive
UPDATE message rate. These rates report the busiest one-second interval.
The queue statistics table reports information for BGP work queues. Items
placed on each of these work queues are as follows:
• The Events queue includes most timer events and configuration changes.
• The Keepalive Tx queue includes timer events to send a KEEPALIVE
message to a peer. The Dec Proc queue includes events that cause the
decision process to be run.
• The Rx Data queue holds incoming BGP messages.
• The RTO Notifications queue includes best route change and next hop
resolution change notifications from the routing table.
• The MIB Queries queue includes pending SNMP queries for BGP status.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console#show ip bgp traffic
Time Since Counters Cleared: 55223 Seconds
BGP Message Statistics
Open Update Notification Keepalive Refresh Total
Recd: 6 11 0 7888 0 7905
Sent: 8 56 3 8465 0 8532
Max Received UPDATE rate: 1 pps
Max Send UPDATE rate: 5 pps
BGP Queue Statistics
Current Max Drops Limit
Events 0 2 0 800
Keepalive Tx 0 3 0 128
Dec Proc 0 3 0 133
2CSNXXX_SWUM204.book Page 1389 Monday, January 25, 2016 1:25 PM