Administrator Guide

Layer 3 Routing Commands 1394
Syntax
show ip bgp vpnv4 {all | rd route-distinguisher [ ipprefix/length ]| vrf vrf-
name
[ ip-prefix/length ] | statistics }
• all — Displays the complete VPNv4 database.
•
rd route-distinguisher —Displays the NLRI prefixes that match the named
route distinguisher.
•
vrf vrf-name —Displays the NLRI prefixes associated with the named VRF
instance.
•
ip-prefix/length — IP address of a network in the routing table and the
length of the mask (0 to 32). The slash mark must be included.
•
statistics — Displays BGP VPNv4 statistics
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec and Global Configuration modes
User Guidelines
The format and field descriptions are the same as for show ip bgp neighbors
with the following exceptions:
• If the peer address (“Remote Address”) is a link local address, the next line
of output indicates the scope of the address.
• No “IPv4 Outbound Update Group” is listed.
• No IPv4 prefix statistics are shown, since this implementation does not
support advertisement of IPv4 prefixes over IPv6 transport.
• “RFC 5549 Support” is displayed only if the BGP neighbor is peered over
IPv6 network.
• If the peer is configured as “autodetect”, the “Remote Address” shows
detected IPv6 address or “Unresolved” if the peer is not detected by the
autodetect feature.
2CSNXXX_SWUM204.book Page 1394 Monday, January 25, 2016 1:25 PM