Administrator Guide

Layer 3 Routing Commands 1420
permit 200:2
permit 200:3
show ip prefix-list
This command displays the contents of IPv4 prefix lists.
Syntax
show ip prefix-list [detail [ prefix-list-name ] | summary [ prefix-list-name ] |
prefix-list-name [ network mask [longer] [first-match] | seq sequence-
number
]] [detail | summary] prefix-list-name [ network network-mask ]
[seq
sequence-number ] [longer] [first-match]
• detail | summary —(Optional) Displays detailed or summarized
information about all prefix lists.
•
prefix-list-name —(Optional) The name of a specific prefix list.
• network—(Optional) The network number
•
mask —Required if a network is specified. The network mask dotted-quad
notation. In dotted-quad notation, the 1 bits must be contiguous and left
justified.
•
seq sequence-number —(Optional) Applies the sequence number to the
prefix list entry. The sequence number of the prefix list entry.
•
longer —(Optional) Displays all entries of a prefix list that are more
specific than the given network/length.
•
first-match —(Optional) Displays the entry of a prefix list that matches
the given network.
Default Configuration
No prefix lists are configured by default.
Command Mode
Privileged Exec mode, Global Configuration mode and all sub-modes.
User Guidelines
The following combinations of parameters are acceptable:
show ip prefix-list
prefix-list-name network / length first-match
2CSNXXX_SWUM204.book Page 1420 Monday, January 25, 2016 1:25 PM