Administrator Guide

Dell Networking CLI 143
dot1x system-auth-control
monitor
Enables 802.1X globally. GC
dot1x timeout guest-vlan-
period
Sets the number of seconds that the switch
waits before authorizing the client if the client
is a dot1x unaware client.
IC
dot1x timeout quiet-period Sets the number of seconds the switch remains
in the quiet state following a failed
authentication attempt.
IC
dot1x timeout re-authperiod Sets the number of seconds between
reauthentication attempts.
IC
dot1x timeout server-
timeout
Sets the number of seconds the switch waits for
a response from the authentication server
before resending the request.
IC
dot1x timeout supp-timeout Sets the time that the switch waits for a
response before retransmitting an Extensible
Authentication Protocol (EAP)-request frame
to the client
IC
dot1x timeout tx-period Sets the number of seconds the switch waits for
a response to an EAP-request/identify frame
from the client before resending the request.
IC
auth-type Set the accepted authorization types for
dynamic RADIUS clients.
DRC
client Sets the CoA client parameters. DRC
ignore Sets the switch to ignore certain authentication
parameters from dynamic RADIUS clients.
DRC
port Sets the port on which to listen for CoA and
disconnect requests from authorized dynamic
RADIUS clients.
DRC
server-key Configures a global shared secret that is
used for all dynamic RADIUS clients that
do not have an individual shared secret
configured.
DRC
show dot1x Displays 802.1X status for the switch or the
specified interface.
PE
Command Description Mode
a
2CSNXXX_SWUM204.book Page 143 Monday, January 25, 2016 1:25 PM