Administrator Guide

Layer 3 Routing Commands 1471
Command Mode
Privileged Exec and User Exec modes, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the configured DHCP pool based on the
entered IPv6 address.
console#show ipv6 dhcp binding 2020:1::
show ipv6 dhcp interface (User Exec)
Use the show ipv6 dhcp interface command in User Exec mode to display
DHCPv6 information for all relevant interfaces or for the specified interface.
If an interface is specified, the optional statistics parameter is available to
view statistics for the specified interface.
Syntax
show ipv6 dhcp interface [ interface-id ] [statistics]
• interface-id —A tunnel or VLAN interface identifier. See Interface Naming
Conventions for interface representation.
•
statistics — Enables statistics display if interface is specified.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Configuration mode and all
Configuration submodes
User Guidelines
Statistics are shown depending on the interface mode (relay, server, or client).
2CSNXXX_SWUM204.book Page 1471 Monday, January 25, 2016 1:25 PM