Administrator Guide

Layer 3 Routing Commands 1473
• interface-id —Any valid IP interface. See Interface Naming Conventions
for interface representation.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec, Configuration mode and all Configuration submodes
User Guidelines
This command shows the DHCP status. Information displayed depends on
the mode.
The command output provides the following information for an interface
configured in client mode. Not all fields will be shown for an inactive client.
Term Description
Mode Displays whether the specified interface is in Client, Relay, or
Server mode.
State State of the DHCPv6 Client on this interface. The valid values
are:
INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW,
REBIND, RELEASE.
S er v er D UI D D H CP v 6 U n iq u e I d en t if i er o f t h e D H CP v 6 S e rv e r o n th i s
interface.
T1 Time The T1 (in seconds) time as indicated by the DHCPv6 Server.
T1 value indicates the time interval after which the address is
requested for renewal.
T2 Time The T2 (in seconds) time as indicated by the DHCPv6 Server.
T2 value indicates the time interval after which the Client
sends Rebind message to the Server in case there are no replies
to the Renew messages.
Interface IAID An identifier for an identity association chosen by this Client.
Leased Address The IPv6 address leased by the DHCPv6 Server for this
interface.
2CSNXXX_SWUM204.book Page 1473 Monday, January 25, 2016 1:25 PM