Administrator Guide

Layer 3 Routing Commands 1535
ip dhcp relay information check-reply
Use the ip dhcp relay information check-reply command to enable DHCP
Relay to check that the relay agent information option in forwarded
BOOTREPLY messages is valid. If an invalid message is received, the relay
agent drops it. This information check will take effect, though enabled, only
when the relay agent interface is enabled to insert the suboptions.
Syntax
ip dhcp relay information check-reply [none]
no ip dhcp relay information check-reply
• none —(Optional) Disables the command function.
Default Configuration
This check is enabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Enable DHCP Relay using the ip helper enable command. Use the global
configuration command ip dhcp relay information option command to
enable processing of DHCP circuit ID and remote agent ID options. DHCP
replies are checked by default. The network administrator should ensure that
only one switch in the path between the DHCP client and server processes
DHCP information options.
Example
The following example enables relay information check on the interface:
console(config)#interface vlan 10
console(config-if-vlan10)#ip dhcp relay information check
2CSNXXX_SWUM204.book Page 1535 Monday, January 25, 2016 1:25 PM