Administrator Guide

Layer 3 Routing Commands 1554
Default Configuration
No route maps are configured by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Policy-based routing must be configured on the VLAN interface that receives
the packets, not on the VLAN interface from which the packets are sent.
Packets matching a deny route map are routed using the routing table. Policy
maps with no set clause are ignored.
When a route-map applied on an interface is changed, i.e. new statements are
added to route-map or match or set terms are added/removed from the route-
map statement, or if any route-map that is applied on an interface is removed,
the entire sequence of route-maps needs to be removed from the interface
and added back again in order to have changed route-map configuration be
effective.
If the administrator removes match or set terms in route-map intermittently,
the counters corresponding to the removed match term are reset to zero.
A route-map statement must contain eligible match/set conditions for policy
based routing in order to be applied to hardware
Valid match conditions are:
match ip address <acl> , match mac-list, match length
Valid set conditions are:
set ip next-hop, set ip default next-hop, set ip precedence
A route-map statement must contain at least one of the match and one of the
set conditions specified above in order it to be eligible to be applied to
hardware. If not, the route-map is not applied to hardware.
An ACL referenced in a route-map may not be edited. Instead, create a new
ACL with the desired changes and update the route-map with the edited
ACL.
2CSNXXX_SWUM204.book Page 1554 Monday, January 25, 2016 1:25 PM