Administrator Guide

Layer 3 Routing Commands 1577
set ip precedence
Use this command to set the three IP precedence bits in the IP packet header
on ingress. Values 0 through 7 are supported. This precedence value may be
used by other QoS services in the switch such as weighted fair queuing
(WFQ) or weighted random early detection (WRED). Use the no form of
this command to remove a set clause from a route map.
Syntax
set ip precedence 0-7
no set ip precedence
• 0 — Sets the routine precedence.
• 1 — Sets the priority precedence.
• 2 — Sets the immediate precedence.
• 3 — Sets the Flash precedence.
• 4 — Sets the Flash override precedence.
• 5 — Sets the critical precedence.
• 6 — Sets the internetwork control precedence.
• 7 — Sets the network control precedence.
Default Configuration
There is no default configuration for this command.
Command Mode
Route Map mode
User Guidelines
The set ip precedence clause may be combined with set ip next-hop or set ip
default next-hop clause in a route map.
Example
console(config-route-map)#set ip precedence 5
2CSNXXX_SWUM204.book Page 1577 Monday, January 25, 2016 1:25 PM