Administrator Guide

Layer 3 Routing Commands 1629
User Guidelines
This command has no user guidelines.
Example
console#show ipv6 interface management statistics
DHCPv6 Client Statistics
-------------------------
DHCPv6 Advertisement Packets Received.......... 0
DHCPv6 Reply Packets Received.................. 0
Received DHCPv6 Advertisement Packets Discard.. 0
Received DHCPv6 Reply Packets Discarded........ 0
DHCPv6 Malformed Packets Received.............. 0
Total DHCPv6 Packets Received.................. 0
DHCPv6 Solicit Packets Transmitted............. 0
DHCPv6 Request Packets Transmitted............. 0
DHCPv6 Renew Packets Transmitted............... 0
DHCPv6 Rebind Packets Transmitted.............. 0
DHCPv6 Release Packets Transmitted............. 0
Total DHCPv6 Packets Transmitted............... 0
show ipv6 mld groups
The show ipv6 mld groups command is used to display information about
multicast groups that MLD reported. The information is displayed only when
MLD is enabled on at least one interface. If MLD was not enabled on any
interfaces, there is no group information to be displayed.
Syntax
show ipv6 mld groups { group-address | vlan vlan-id }
• group-address — The group address to display.
•
vlan-id — A valid VLAN id.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Configuration mode and all Configuration submodes
2CSNXXX_SWUM204.book Page 1629 Monday, January 25, 2016 1:25 PM