Administrator Guide

Layer 3 Routing Commands 1635
Example
console#show ipv6 mld host-proxy
Interface Index.............................. vlan 10
Admin Mode................................... Enabled
Operational Mode............................. Enabled
Version............................................ 3
Num of Multicast Groups............................ 0
Unsolicited Report Interval........................ 1
Querier IP Address on Proxy Interface..... fe80::1:2:5
Older Version 1 Querier Timeout............. 00:00:00
Proxy Start Frequency...............................1
show ipv6 mld host-proxy groups
Use the show ipv6 mld host-proxy groups command to display information
about multicast groups that the MLD Proxy reported.
Syntax
show ipv6 mld host-proxy groups
Default Configuration
There is no default configuration for this command.
Operational Mode Indicates whether MLD Proxy is operationally enabled or
disabled. This is a status parameter.
Version The present MLD host version that is operational on the proxy
interface.
Number of
Multicast Groups
The number of multicast groups that are associated with the
MLD-Proxy interface.
Unsolicited Report
Interval
The time interval at which the MLD-Proxy interface sends
unsolicited group membership reports.
Querier IP Address
on Proxy Interface
The IP address of the Querier, if any, in the network attached to
the upstream interface (MLD-Proxy interface).
Older Version 1
Querier Timeout
The interval used to timeout the older version 1 queriers.
Proxy Start
Frequency
The number of times the MLD-Proxy has been stopped and
started.
2CSNXXX_SWUM204.book Page 1635 Monday, January 25, 2016 1:25 PM