Administrator Guide

Layer 3 Routing Commands 1648
• interface-id —An interface identifier (physical or port-channel).
Default Configuration
By default, no RA guard policies are applied to any interface.
Command Mode
Privileged Exec, Global Configuration, and all submodes
User Guideline
There are no user guidelines for this command.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-if-vlan10)#show ipv6 snooping counters
IPv6 Dropped Messages
RA (Router Advertisement – ICMP type 134),
REDIR (Router Redirect – ICMP type 137)
Interface RA REDIR
--------------- ---------- ----------
Gi1/0/1 0 0
Gi1/0/2 431 6599
show ipv6 traffic
Use the show ipv6 traffic command in User Exec mode to show traffic and
statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [vlan vlan-id | tunnel tunnel-id | loopback loopback-id ]
• vlan-id — Valid VLAN ID, shows information about traffic on a specific
interface or, without the optional parameter, shows information about
traffic on all interfaces.
•
tunnel-id — Tunnel identifier. (Range: 0-7)
2CSNXXX_SWUM204.book Page 1648 Monday, January 25, 2016 1:25 PM