Administrator Guide

Layer 3 Routing Commands 1651
MAC Address used by Routing VLANs: 00:02:BC:00:30:68
VLAN ID IPv6 Address/Prefix Length
------- ---------------------------------------
1
traceroute ipv6
Use the traceroute ipv6 command in Privileged Exec mode to determine the
path and measure the transit delay to another device in the network. The
transit delays are measured for each hop in the network.
Syntax
traceroute ipv6 {ipv6-address|hostname} [count 1-10 ] [init-ttl 1-255 ]
[interval
1-60 ] [max-fail 0-255 ] [max-ttl 1-255 ] [port 1-65535 ] [size 0-
39936
] [source { ipv6-address | loopback loopback-id | vlan vlan-id }]
• ipv6-address | hostname—The target IP address or host to ping.
• out-of-band—Send the ping over the out-of-band interface.
• vlan-id—The VLAN over which to send the echo request.
• loopback-id—Use the source address from the selected loopback. (Range
0-7)
• count—The number of echo request packets to send for each ttl value.
(Range 1-10. Default 3).
• interval—The time (in seconds) between successive echo requests.
Default 3.
• init-ttl—The initial TTL sent in the ICMP echo request packets (Range 1-
255. Default 1).
• max-ttl—The maximum ttl sent in the ICMP echo request packet (Range
1-255, default 30). Must be equal to or larger than init-ttl.
• port—The destination UDP port of the probe. (Range 1-65535).
• size—The packet size padding in bytes. (Range 0-39936, default 0).
• source—Use the specified source IP address, loopback address, VLAN
address, tunnel or out-of-band interface address in the transmitted
packets.
2CSNXXX_SWUM204.book Page 1651 Monday, January 25, 2016 1:25 PM