Administrator Guide

Layer 3 Routing Commands 1672
Example
console#show ip mfc
MFC IPv4 Mode.................................. Disabled
MFC IPv6 Mode.................................. Disabled
MFC Entry Count ............................... 0
Current multicast IPv4 protocol................ PIMSM
Current multicast IPv6 protocol................ No protocol enabled.
Total software forwarded packets .............. 0
-------------------- -------------------- ---------- --------------
Source Address Group Address Protocol Pkts
Forwarded in SW
-------------------- -------------------- ---------- --------------
192.168.28.4 232.1.2.3 PIM-SM 61
show ip multicast
Use the show ip multicast command in Privileged Exec mode to display the
system-wide multicast information.
Syntax
show ip multicast
Default Configuration
This command has no default configuration.
Field Description
MFC IPv4 Mode Enabled when IPv4 Multicast routing is operational.
MFC IPv6 Mode Enabled when IPv6 Multicast routing is operational.
MFC Entry Count The number of entries present in MFC.
Total Pkts Forwarded in
SW
Total Number of multicast packets forwarded in software.
Source Address Source address of the multicast route entry.
Group Address Group address of the multicast route entry.
Protocol The current operating multicast routing protocol.
Pkts Forwarded in SW Number of multicast packets that are forwarded in sofware
for a specific multicast route entry .
2CSNXXX_SWUM204.book Page 1672 Monday, January 25, 2016 1:25 PM