Administrator Guide

Layer 3 Routing Commands 1680
show ip pim interface
The show ip pim interface command displays the PIM interface status
parameters. If the interface number is not is specified, the command displays
the status parameters of all the PIM-enabled interfaces.
Syntax
show ip pim interface [vlan vlan-id ]
• vlan-id — A valid VLAN ID for which multicast routing has been enabled.
Field Descriptions
Default Configuration
There is no default configuration for this command.
Command Mode
User Exec and Privileged Exec modes, Configuration mode and all
Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
(console) #show ip pim interface
Field Description
Mode Active PIM Protocol
Interface Interface number
Hello Interval Hello interval value
Join-prune Interval Join-prune interval value
DR Priority DR Priority configured on this interface
BSR Border Whether or not this interface is configured as a BSR Border
Neighbor Count Number of PIM Neighbors learnt on this interface
Designated-Router IP address of the elected DR on the interface
2CSNXXX_SWUM204.book Page 1680 Monday, January 25, 2016 1:25 PM