Administrator Guide

Layer 3 Routing Commands 1687
IPv6 Multicast Commands
Dell Networking N3000/N4000 Series Switches
The Dell Network N1500/N2000 series supports limited routing and multicast
capabilities. See the Users Configuration Guide section “Feature Limitations and
Platform Constants” for supported capabilities.
This section explains the following commands:
clear ipv6 mroute
This command is used to selectively clear dynamic IPv6 multicast entries
from the cache.
Syntax
clear ipv6 mroute { * | group-address [ source-address ] }
* —Deletes all IPv6 entries from the IP multicast routing table.
group-address — IPv6 address of the multicast group.
source-address —IPv6 address of a multicast srouce that is sending multicast
traffic to the group.
clear ipv6 mroute ipv6 pim sparse-mode
ipv6 pim (VLAN Interface config) ipv6 pim ssm
ipv6 pim bsr-border show ip mroute group
ipv6 pim bsr-candidate show ip mroute source
ipv6 pim dense-mode show ipv6 pim
ipv6 pim dr-priority show ipv6 pim bsr-router
ipv6 pim hello-interval show ipv6 pim interface
ipv6 pim join-prune-interval show ipv6 pim neighbor
ipv6 pim register-threshold show ipv6 pim rp-hash
ipv6 pim rp-address show ipv6 pim rp mapping
ipv6 pim rp-candidate show ipv6 pim statistics
2CSNXXX_SWUM204.book Page 1687 Monday, January 25, 2016 1:25 PM