Administrator Guide

Layer 3 Routing Commands 1698
Interface Interface-Mode Operational-Status
--------- -------------- ------------------
Vl1 Enabled Operational
show ipv6 pim bsr-router
Use the show ipv6 pim bsr-router command to display the bootstrap router
(BSR) information.
Syntax
show ipv6 pim bsr-router { candidate | elected }
• candidate—Show the IPv6 PIM candidate bootstrap router information.
• elected—Show the IPv6 elected PIM bootstrap router information.
Default Configuration
There is no default configuration for this command.
Command Mode
User Exec, Privileged Exec modes, Configuration mode and all Configuration
submodes
User Guidelines
Field descriptions are shown in the following table.
Field Description
BSR Address Address of the BSR
BSR Priority Configured BSR priority
BSR Hash Mask
Length
Configured hash mask length
Next Bootstrap
Message
Remaining time until a BSR message is sent
Next Candidate RP
Advertisement
Time remaining until the next RP advertisement is sent.
2CSNXXX_SWUM204.book Page 1698 Monday, January 25, 2016 1:25 PM