Administrator Guide

Layer 3 Routing Commands 1714
area default-cost (Router OSPF)
Use the area default-cost command in Router OSPF Configuration mode to
configure the advertised default cost for the stub area. Use the no form of the
command to return the cost to the default value.
Syntax
area area-id default-cost integer
no area area-id default-cost
area nssa translator-
stab-intv
distance ospf maximum-paths show ip ospf interface
brief
area range (Router
OSPF)
distribute-list out network area show ip ospf interface
stats
area stub enable nsf show ip ospf lsa-group
area stub no-
summary
exit-overflow-
interval
nsf helper show ip ospf neighbor
area virtual-link external-lsdb-limit nsf helper strict-lsa-
checking
show ip ospf range
area virtual-link
authentication
ip ospf area nsf restart-interval show ip ospf statistics
area virtual-link
dead-interval
ip ospf
authentication
passive-interface
default
show ip ospf stub table
area virtual-link
hello-interval
ip ospf cost passive-interface show ip ospf traffic
area virtual-link
retransmit-interval
ip ospf database-
filter all out
redistribute (BGP) show ip ospf virtual-link
area virtual-link
transmit-delay
ip ospf dead-
interval
router-id show ip ospf virtual-
links brief
auto-cost ip ospf hello-
interval
router ospf timers pacing flood
bandwidth ip ospf mtu-ignore show ip ospf timers pacing lsa-group
bfd –– timers spf
2CSNXXX_SWUM204.book Page 1714 Monday, January 25, 2016 1:25 PM