Administrator Guide

Layer 3 Routing Commands 1726
• area-id —Identifies the OSPF stub area to configure. (Range: IP address or
decimal from 0-4294967295)
•
router-id —Valid IP address.
•
authentication —Specifies authentication type.
•
message-digest —Specifies that message-digest authentication is used.
•
null —No authentication is used. Overrides password or message-digest
authentication if configured for the area.
•
hello-interval seconds —Number of seconds to wait before sending hello
packets to the OSPF virtual interface. (Range: 1–65535)
•
dead-interval seconds —Number of seconds to wait before the OSPF
virtual interface on the virtual interface is assumed to be dead. (Range:
1–65535)
•
retransmit-interval seconds —The number of seconds to wait between
retransmitting LSAs if no acknowledgement is received. (Range: 0–3600)
•
transmit-delay seconds —Number of seconds to increment the age of the
LSA before sending, based on the estimated time it takes to transmit from
the interface. (Range: 0–3600)
•
md5 —Use MD5 Encryption for an OSPF Virtual Link.
•
key —Authentication key for the specified interface. (Range: 8 bytes or less
if the authentication type is simple and 16 bytes or less if the type is
encrypt.)
•
key-id —Authentication key identifier for the authentication type encrypt.
(Range: 0–255)
Default Configuration
Parameter Default
area-id No area ID is predefined.
router-id No router ID is predefined.
hello-interval
seconds
10 seconds
retransmit-interval
seconds
5 seconds
2CSNXXX_SWUM204.book Page 1726 Monday, January 25, 2016 1:25 PM