Administrator Guide

Layer 3 Routing Commands 1746
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan1)#ip ospf area 192.168.1.10
console(config-if-vlan1)#ip ospf area 3232235786
ip ospf authentication
Use the ip ospf authentication command in the Interface Configuration
mode to set the OSPF Authentication Type and Key for the specified
interface. Use the no form of the command to return the authentication type
to the default value.
Syntax
ip ospf authentication {none | {simple key } | {encrypt key key-id }}
no ip ospf authentication
• encrypt — MD5 encrypted authentication key.
•
key — Authentication key for the specified interface. (Range: 8 bytes or
less if the authentication type is
simple and 16 bytes or less if the type is
encrypt .)
•
key-id — Authentication key identifier for the authentication type
encrypt . (Range: 0–25)
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
Unauthenticated interfaces do not need an authentication key or
authentication key ID.
2CSNXXX_SWUM204.book Page 1746 Monday, January 25, 2016 1:25 PM