Administrator Guide

Layer 3 Routing Commands 1756
If the router is configured to enter stub router mode on startup (max-metric
router-lsa on-startup), and one then enters max-metric router lsa, there is no
change. If OSPF is administratively in stub router mode (the max-metric
router-lsa command has been given), and one configures OSPF to enter stub
router mode on startup (max-metric router-lsa on-startup), OSPF exits stub
router mode (assuming the startup period has expired) and the configuration
is updated.
The command no max-metric router-lsa clears either type of stub router
mode (always or on-startup) and resets the summary-lsa option. If OSPF is
configured to enter global configuration mode on startup, and during normal
operation one wants to immediately place OSPF in stub router mode, one
may issue the command no max-metric router-lsa on-startup. The command
no max-metric router-lsa summary-lsa causes OSPF to send summary LSAs
with metrics computed using normal procedures defined in RFC 2328.
maximum-paths
Use the maximum-paths command in Router OSPF Configuration mode to
set the number of paths that OSPF can report for a given destination. Use the
no form of the command to reset the number to the default value.
Syntax
maximum-paths integer
no maximum-paths
• integer — Number of paths that OSPF can report for a given destination.
(Range: 1–4.)
Default Configuration
4 is the integer default value.
Command Mode
Router OSPF Configuration mode.
2CSNXXX_SWUM204.book Page 1756 Monday, January 25, 2016 1:25 PM