Administrator Guide

Layer 3 Routing Commands 1763
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1
redistribute (OSPF)
Use the redistribute command in Router OSPF Configuration mode to
configure OSPF protocol to allow redistribution of routes from the specified
source protocol/routers. Use the no version of the command to disable
redistribution from the selected source or to reset options to their default
values.
Syntax
redistribute protocol [metric metric-value ] [metric-type type-value ] [tag
tag-value ] [subnets]
no redistribute {
protocol }[metric] [metric-type] [tag] [subnets]
• protocol —One of the following:
– static—Specifies that static routes are to be redistributed.
– connected—Specifies that connected routes are to be redistributed.
– bgp—Specifies BGP originated routes are to be redistributed.
– rip—Specifies RIP originated routes are to be redistributed.
•
static —Specifies that static routes are to be redistributed.
–
connected —Specifies the connected routes are to be redistributed.
•
metric-value —Specifies the metric to use when redistributing the route.
(Range: 0–16777214)
•
type-value —One of the following:
2CSNXXX_SWUM204.book Page 1763 Monday, January 25, 2016 1:25 PM