Administrator Guide

Layer 3 Routing Commands 1773
AS_OPAQUE LSA Count............................ 0
AS_OPAQUE LSA Checksum......................... 0
New LSAs Originated............................ 300269
LSAs Received.................................. 300276
LSA Count...................................... 6020
Maximum Number of LSAs......................... 36968
LSA High Water Mark............................ 6020
AS Scope LSA Flood List Length................. 0
Retransmit List Entries........................ 0
Maximum Number of Retransmit Entries........... 147872
Retransmit Entries High Water Mark............. 32616
NSF Helper Support............................. Always
NSF Helper Strict LSA Checking................. Enabled
show ip ospf abr
The show ip ospf abr command displays the internal OSPF routing table
entries to Area Border Routers (ABR). This command takes no options.
Syntax
show ip ospf abr [vrf vrf-name ]
• vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N4000 series switches.
Example
console#show ip ospf abr
Type Router Id Cost Area ID Next Hop Next Hop
2CSNXXX_SWUM204.book Page 1773 Monday, January 25, 2016 1:25 PM