Administrator Guide

Layer 3 Routing Commands 1783
IP Address........................... 172.20.11.2
Subnet Mask.......................... 255.255.255.0
Secondary IP Address(es).............
OSPF Admin Mode...................... Enable
OSPF Area ID......................... 0.0.0.0
OSPF Network Type.................... Point-to-Point
Router Priority...................... 1
Retransmit Interval.................. 5
Hello Interval....................... 3
Dead Interval........................ 12
LSA Ack Interval..................... 1
Transmit Delay....................... 1
Authentication Type.................. None
Metric Cost.......................... 100 (computed)
Passive Status....................... Non-passive interface
OSPF Mtu-ignore...................... Disable
Flood Blocking....................... Disable
State................................ point-to-point
Number of Link Events................ 1
Local Link LSAs...................... 0
Local Link LSA Checksum.............. 0
show ip ospf interface brief
Use the show ip ospf interface brief command in Privileged EXEC mode to
display brief information for the IFO object or virtual interface tables.
Syntax
show ip ospf interface brief [vrf vrf-name ]
• vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
2CSNXXX_SWUM204.book Page 1783 Monday, January 25, 2016 1:25 PM