Administrator Guide

Layer 3 Routing Commands 1784
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N4000 series switches.
Example
The following example displays brief information for the IFO object or virtual
interface tables.
console#show ip ospf interface brief
Hello Dead Retrax LSA
Admin Router Int. Int. Int. Tranx Ack
Interface Mode Area ID Prior. Cost Val. Val. Val. Delay Intval
------------ -------- ----------- ------ ----- ----- ----- ------ ------ ------
Vl10 Enable 0.0.0.10 1 10 10 40 5 1 1
Vl20 Enable 0.0.0.1 1 10 10 40 5 1 1
Vl100 Enable 0.0.0.111 1 10 10 40 5 1 1
loopback 1 Enable 0.0.0.0 1 1 10 40 5 1 1
show ip ospf interface stats
Use the show ip ospf interface stats command in User EXEC mode to display
the statistics for a specific interface. The information is only displayed if
OSPF is enabled.
Syntax
show ip ospf interface stats vlan vlan-id
• vlan-id — Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM204.book Page 1784 Monday, January 25, 2016 1:25 PM