Administrator Guide

Layer 3 Routing Commands 1790
console#show ip ospf neighbor 3.3.3.3
Interface...................................... 0/25
Neighbor IP Address............................ 172.20.25.3
Interface Index................................ 25
Area Id........................................ 0.0.0.0
Options........................................ 0x2
Router Priority................................ 1
Dead timer due in (secs)....................... 10
Up Time........................................ 4 days 3 hrs 33 mins 36 secs
State.......................................... Full/PtP
Events......................................... 4
Retransmitted LSAs............................. 32
Retransmission Queue Length.................... 0
Restart Helper Status........................ Not helping
Restart Helper Exit Reason................... Not attempted
show ip ospf range
Use the show ip ospf range command in Privileged EXEC mode to display
information about the area ranges for the specified area-id.
Syntax
show ip ospf range [vrf vrf-name ] area-id
• vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
•
area-id —Identifies the OSPF area whose ranges are being displayed.
(Range: IP address or decimal from 0–4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
2CSNXXX_SWUM204.book Page 1790 Monday, January 25, 2016 1:25 PM