Administrator Guide

Layer 3 Routing Commands 1794
• vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N4000 series switches.
Example
The following example displays the OSPF stub table.
console(config)#show ip ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
------------- ------------- ---------- -----------------
0.0.0.1 Normal 1 Enable
show ip ospf traffic
Use the show ip ospf traffic command in Privileged EXEC mode to display
OSPFv2 packet and LSA statistics and OSPFv2 message queue statistics.
Packet statistics count packets and LSAs since OSPFv2 counters were last
cleared (using the
clear ip ospf counters command.)
NOTE: Note that the clear ip ospf counters command does not clear the message
queue high water marks.
Syntax
show ip ospf traffic [vrf vrf-name ]
2CSNXXX_SWUM204.book Page 1794 Monday, January 25, 2016 1:25 PM