Administrator Guide

Layer 3 Routing Commands 1797
• vrf-name —The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
•
area-id — Identifies the OSPF area whose ranges are being displayed.
(Range: IP address or decimal from 0–4294967295)
•
neighbor-id — Identifies the neighbor’s router ID. (Range: Valid IP
address)
Default Configuration
Show information for all OSPF Virtual Interfaces.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N4000 series switches.
Example
The following example displays the OSPF Virtual Interface information for
area 10 and its neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID............................. 192.168.2.2
Hello Interval................................. 10
Dead Interval.................................. 655555
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... down
Metric......................................... 0
Neighbor State................................. down
Authentication Type............................ MD5
Authentication Key............................. "test123"
Authentication Key ID.......................... 100
2CSNXXX_SWUM204.book Page 1797 Monday, January 25, 2016 1:25 PM