Administrator Guide

Layer 3 Routing Commands 1813
Syntax
area area-id virtual-link router-id [hello-interval seconds ] [retransmit-
interval
seconds ] [transmit-delay seconds ] [dead-interval seconds ]
no area
area-id virtual-link router-id id [hello-interval] [retransmit-interval]
[transmit-delay] [dead-interval]
• area-id —Valid OSPFv3 area identifier (or decimal value in the range of 0-
4294967295).
•
router-id —Identifies the Router ID or valid IP address of the neighbor.
•
hello-interval seconds —Number of seconds to wait before sending hello
packets to the OSPF virtual interface. (Range: 1–65535)
•
dead-interval seconds —Number of seconds to wait before the OSPF
virtual interface on the virtual interface is assumed to be dead. (Range:
1–65535)
•
retransmit-interval seconds —The number of seconds to wait between
retransmitting LSAs if no acknowledgement is received. (Range: 0–3600)
•
transmit-delay seconds —Number of seconds to increment the age of the
LSA before sending, based on the estimated time it takes to transmit from
the interface. (Range: 0–3600)
Default Configuration
Parameter Default
area-id No area ID is predefined.
router-id No router ID is predefined.
hello-interval
seconds
10 seconds
retransmit-interval
seconds
5 seconds
transmit-delay
seconds
1 second
dead-interval
seconds
40 seconds
2CSNXXX_SWUM204.book Page 1813 Monday, January 25, 2016 1:25 PM