Administrator Guide

Dell Networking CLI 180
Loopback Interface
Multicast
show ipv6 protocols Displays information about the configured
IPv6 routing protocols.
PE or GC
show ipv6 route Displays the IPv6 routing table. PE
show ipv6 route
preferences
Shows the preference value associated with
the type of route.
PE
show ipv6 route summary Displays a summary of the routing table. PE
show ipv6 snooping
counters
Displays the RA guard dropped packet
counters.
PE
GC
show ipv6 traffic Shows traffic and statistics for IPv6 and
ICMPv6.
UE
show ipv6 vlan Displays IPv6 VLAN routing interface
addresses.
PE
traceroute ipv6 Discovers the routes that packets actually
take when traveling to their destination
through the network on a hop-by-hop basis.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 100.
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see Mode Types on page 100.
arp Enters the Interface Loopback configuration
mode.
GC
show interfaces loopback Displays information about configured
loopback interfaces.
PE
Command Description Mode
a
arp Adds an administrative scope multicast
boundary.
IC
ip mroute Creates a static multicast route for a source
range.
GC
Command Description Mode
a
2CSNXXX_SWUM204.book Page 180 Monday, January 25, 2016 1:25 PM