Administrator Guide

Dell Networking CLI 182
IPv6 Multicast
show ip multicast interface Displays the multicast information for the
specified interface.
PE
show ip mroute Displays a summary or all the details of the
multicast table.
PE
show ip mroute group Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mroute source Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mroute static Displays all the static routes configured in the
static mcast table.
PE
show ip pim Displays information about the interfaces
enabled for PIM.
UE or
PE
show ip pim bsr-router Displays the bootstrap router (BSR)
information.
PE
show ip pim interface Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
UE or
PE
show ip pim neighbor Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pim rp-hash Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
show ip pim rp mapping Displays the mappings for the PIM group to the
active rendezvous points (RPs).
UE or
PE
show ip pim statistics Displays the count of PIM sparse mode
received control packets per VLAN.
PE or
GC
a. For the meaning of each Mode abbreviation, see Mode Types on page 100.
Command Description Mode
a
clear ipv6 mroute Selectively clears dynamic IPv6 multicast
entries from the cache.
PE
Command Description Mode
a
2CSNXXX_SWUM204.book Page 182 Monday, January 25, 2016 1:25 PM