Administrator Guide

Layer 3 Routing Commands 1849
show ipv6 ospf interface
Use the show ipv6 ospf interface command in Privileged Exec mode to
display the information for the IFO object or virtual interface tables.
Syntax
show ipv6 ospf interface [ interface-type interface-number ]
• interface-type —The interface type, VLAN, tunnel or loopback
•
interface-number —The valid interface number, a valid VLAN ID, tunnel
identifier (Range: 0–7) or loopback identifier (Range: 0–7).
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the information in VLAN 11’s virtual
interface tables.
console#show ipv6 ospf interface vlan 11
IP Address..................................... 11.11.11.11
ifIndex........................................ 1
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 10 (computed)
OSPF Mtu-ignore................................ Disable
2CSNXXX_SWUM204.book Page 1849 Monday, January 25, 2016 1:25 PM