Administrator Guide

Layer 3 Routing Commands 1852
show ipv6 ospf interface vlan
Use the show ipv6 ospf interface vlan command in Privileged Exec mode to
display OSPFv3 configuration and status information for a specific VLAN.
Syntax
show ipv6 ospf interface vlan { vlan-id | brief}
• vlan-id — Valid VLAN ID. Range is 1-4093.
•
brief — Displays a snapshot of configured interfaces.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays OSPF interface VLAN information.
console#show ipv6 ospf interface vlan 10
IPv6 Address............................. FE80::2FC:E3FF:FE90:44
ifIndex.................................. 634
OSPF Admin Mode.......................... Enable
OSPF Area ID............................. 0.0.0.1
Router Priority.......................... 1
Retransmit Interval...................... 5
Hello Interval........................... 10
Dead Interval............................ 40
LSA Ack Interval......................... 1
Iftransit Delay Interval................. 1
Authentication Type...................... None
Metric Cost.............................. 10 (computed)
OSPF Mtu-ignore.......................... Disable
OSPF Interface Type...................... broadcast
State.................................... backup-designated-router
Designated Router........................ 1.1.1.1
Backup Designated Router................. 2.2.2.2
2CSNXXX_SWUM204.book Page 1852 Monday, January 25, 2016 1:25 PM