Administrator Guide

Layer 3 Routing Commands 1853
Number of Link Events.................... 46
show ipv6 ospf neighbor
Use the show ipv6 ospf neighbor command in Privileged Exec mode to
display information about OSPF neighbors. If a neighbor IP address is not
specified, the output displays summary information in a table. If an interface
or tunnel is specified, only the information for that interface or tunnel
displays. The information below only displays if OSPF is enabled and the
interface has a neighbor.
Syntax
show ipv6 ospf neighbor [ interface-type interface-number ] [ neighbor-id ]
• interface-type —Interface type, vlan or tunnel.
•
interface-number —A valid interface number, a valid VLAN ID or tunnel
identifier. (Range is 0-7).
•
neighbor-id —Valid IP address of the neighbor about which information is
displayed.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about OSPF neighbors, in the
first case in a summary table, and in the second in a table specific to tunnel 1.
console#show ipv6 ospf neighbor
Router ID Priority Intf Interface State Dead
ID Time
--------- -------- ---- ----------- ------------- ----
2CSNXXX_SWUM204.book Page 1853 Monday, January 25, 2016 1:25 PM